 |
| Category >>
Therapy
|
| binauralBeatsHarmonics |
This can switch pan for binaural, can center the frequencies and can make off the binaural. Centering frequency mean the base frequency it's on the average between left and right.
Label with number of active tones. If this becomes red, the phase between frequencies it's outside of the synchronization. If you click it, the tones will synchronize in the phase. Synchronization in the phase is done if play button is clicked too. It's only necessary in rare cases, if annoying out of phases sync occur
|
|
|
 |
| Category >>
Filter
|
| twinPhaser |
twinPhaser it's a double (left and right channel) phasing effect . Very low resources taken!
Your guitar, leads and drums will sound very original!
Features:
Two channel settings for left and right.
Frequency, rate, depth, feedback and mix amount for each channel
|
|
|
 |
| Category >>
Distortion
|
| twinCrusherPro |
LFOs sync button will synchronously positions of LFOs.
Antialiasing button will reduce peaks and other sharp sounds.
Visualization of modulated parameter value.
Nice presets for guitar, drums, lead, vibrato, tremolo, phased and many others.
Free for 60 seconds.
Tips:
Value input from keyboard: go over the knob and right click, insert value from keyboard then hit enter.
Set default value: double click on the knob
Requirements:
DAW (VST host)
|
|
|
 |
| Category >>
Stereo
|
| panOscillator |
panOscillator make pan position oscillating and enhance your stereo signal. Extremely low resources taken!
Features:
Pan out oscillator from left to right.
Host synchronization oscillator.
Pan width for stereo enhanced.
Pan offset to play around.
Start position which can make phase shift
|
|
|
 |
| Category >>
Delay
|
| lfoDelay |
One filter on delay target or out target. Low resources taken!
LFO Delay for unique delay effects.
Features:
Two LFOs which can modulate: Delay Rate, Dry Mix, Wet Mix, Pan Width, Feedback, Filter Freq, Filter Bandwidth, Filter Mix
The LFOs working synchronously also can make phase shift by LFO reset automation.
LFO reset to back LFO phase to start.
LFO offset is value of modulated parameter.
Visualization of modulated parameter value.
One filter Lowpass, Highpass or Bandpass. Can set to delay target or out target
|
|
|
|
|
3LufsMeter
